SRT Primer/surfacer (AC2)
السعر عند الطلب
كلّ منتجات المتجر ←
الوصف
Two-component acrylic-urethane primer/surfacer
المواصفات
| العبوة | Component A : 0.9 L in metal can Component B “SRT AC2 drier” : 0.45 L in metal can |
| اللون | Gray or yellow |
| Application Instruction — Mixing Ratio | (by volume) Comp.A Comp.B 2 1 Stir well individual components before mixing |
| Application Instruction — Pot life | 2 hours (higher temperatures will shorten the potlife sharply) |
| Application Instruction — Thinner / Cleaner | If required, S603 “ known as thinner ST2” is used for thinning and cleaning |
| Technical Information — Flexibility | Excellent |
| Technical Information — Recommended film thickness | 50 microns “dry, after sanding” |
| عدد الطبقات | 2-3 “allow 5-10 minutes to flash between coats” |
| زمن الجفاف | 24 hours |
| Drying Time — Note | Drying times can be affected by many factors such as temperature, ventilation and coat thickness. Higher temperatures will shorten the drying times |
| Technical Information — Adhesion | Excellent |
| Substrate Treatment — Recoating | Fine sanded AC2 may be filled with PE Putty (fine), AC putty or / and coated by almost all kinds of automotive coatings “including heat curing 2k coatings” |
| Drying Time — Dry to Sand | 24 hours “minimum recoat time” |
| Substrate Treatment — Surface Preparation (repair area) | 1. Remove flecks of old paint with a scrapper, sandpaper, or SIP Paint Remover. 2. Remove dirt and water-soluble contaminants by washing with detergent and hot water solution. Rinse well and wipe surfaces thoroughly with a clean dry cloth. 3. Remove grease, oil and other contaminants with thinner (S |
| Substrate Treatment — Sanding | First, sand AC2 with 180-240 grit treated sandpaper. Then, finish sanding with 320-400 grit treated sandpaper. When sanding, a special attention should be taken toward dry to sand condition. Remove sanding residue using air pressure then clean by solvent (S100 or S501). Note: If needed, for best lev |