EPX66
السعر عند الطلب
كلّ منتجات المتجر ←
الوصف
EPX 66 is a trowelled flooring system based on a three-component epoxy, used mainly when high mechanical load is required
المواصفات
| اللمسة النهائية | flat (ASTM-D523) |
| العبوة | Component A “base” : 1.7 L in metal can Component B “drier:CAT40” : 0.6 in metal can Component C “special filler” : 8 kg “diameter: 0.5 to 1 mm approx.” or 16 kg “diameter: 3 to 6 mm” (dry and dust free), or according to needs with different diameter ranges. Mixing of components A, B, and C will pro |
| اللون | Translucent |
| الرمز | EPX66 |
| Application Instruction — Mixing Ratio | 1.7 to 0.9 L (A to B); the required quantity of clean, dry and dust free filler or special stones (component C) will be added according to the filler or stone diameter that will fit with the flooring thickness to be applied. Pretest a small amount of filler or stones to determine the required weight |
| Application Instruction — Mixing | The individual components (A and B) of EPX66 should be thoroughly stirred. Then component B “drier” should be poured into component A “base” container and mixed thoroughly using a slow speed mixer for at least 3 minutes to achieve uniform consistency; “DO NOT USE HIGH SPEED MIXER”. And finally add t |
| Application Instruction — Pot life | 30 minutes (higher temperatures will shorten the potlife sharply) |
| Application Instruction — Thinner / Cleaner | Do not thin. Due to Potlife limitations, clean all mixing and applying tools by thinner S405 “known as Epoxsol” immediately after application is completed |
| Technical Information — Volume Solids | 100 %. (ASTM-D2697) |
| Technical Information — Recommended film thickness | 1-4 cm “dry” |
| التغطية (م²/لتر) | 0.1 m²/L at 1cm “dry” |
| Technical Information — Water resistance | Good |
| Technical Information — Abrasian Resistance | Good |
| Technical Information — Chemical Resistance | Good (A separate leaflet CHR01 is available) |
| Technical Information — Solvent Resistance | Good (A separate leaflet CHR01 is available) |
| عدد الطبقات | 1 |
| Technical Information — Specific Gravity (mixed) | 1.94 kg/L (ASTM C97) |
| زمن الجفاف | 6 hours (ASTM-D1640) |
| Drying Time — Fully Cured | 7 days |
| Technical Information — Compressive Strength | 17.8 N/mm² (ASTM C170) |
| Technical Information — Compressive Test* Load | 47400 N (ASTM C170) |
| Technical Information — Flexural Test* Load | 925 N (ASTM C120) Flexural strength : 9.7 N/mm² (ASTM C120) *When mixing components A and B with 16 kg of filler (diameter: 3 to 6 mm) |