AC Surfacer

السعر عند الطلب

الوصف

One component nitrocellulose surfacer

العبوة	3.6 L or 0.9 L in metal can
Technical Information — Flexibility	Very good
Technical Information — Recommended film thickness	50 microns “dry, after sanding”
عدد الطبقات	2-3
زمن الجفاف	30 minutes
Drying Time — Note	Drying times can be affected by many factors such as temperature, ventilation and coat thickness. Higher temperatures will shorten the drying times
Application Instruction — Cleaner	Thinner S501 or S502 are used for thinning or cleaning. Mixing ratio with thinner depends mainly on temperature
Application Instruction — Note	Stirr well before mixing
Technical Information — Adhesion	Good
Substrate Treatment — Surface Preparation	1. Fill surfaces with suitable putty. 2. Shape and sand filler using 180-240 and 320-400 grit treated sandpaper respectively. 3. Remove sanding residue using air pressure then clean by thinner (S100 or S501). 4. Apply 2-3 coats of AC Surfacer immediately after surface preparation. Note: If needed, f
Substrate Treatment — Recoating	In general, fine sanded AC-Surfacer is considered to be a universal intermediate coat. It can be topcoated by almost all kinds of topcoats. Note: It is recommended to apply SRT Primer/Surfacer (AC2) instead of AC surfacer when finishing is achieved by 2k-coatings “such as SRT Coat or SRT Clearcoat”
Drying Time — Dry to Sand	2 hours “minimum recoat time”